I-Like Red Gasket Maker is for high temperature applications up to 343C: Safe for oxygen sensor equipped vehicles. Excellent heat control and torque retention for overhead cam and timing chain covers.
Dries tough, flexible and improves high temperature performance. Resists most engine fluids.
85g/PC; Blistercard;
200 sets/box, 6 bpxes/carton;
500 cartons/20'ft container
Carton Size: 655x365x230mm
1. Clean the surface to get rid of the rust, oil, or any dirty.
2. Cut the cap point, twists the cap mouth, cut at 45 degree angle beveling according to need.
3. In order to get the smooth glue, hold the bottle at 45 degree angle, squeeze the glue through cap mouth.
4. If further sealing needed, please finished operation within 5 minutes, wipe off the surplus glue with dry tissue.
5. After completely solidify, amend the glue by knife.
1. Operation should be carried out in well ventilated area.
2. Keep out of the reach of children; Non-toxic after solidifies completely, avoid eye contact before solidification, if touches the eye carelessly, use massive water to wash, if serious go to see a doctor.
3. When operation, must hold the glue steadily, cannot separate, guards against mixes in the air and form bubble, affects the seal effect.
4. After operation, take off the cap mouth immediately, close the packing cover tightly to prevent the moisture enter and cause solidification. Wipe off the glue left at glue mouth.
5. This product should be operated at temperature 5-4C, relative humidity 40-80%
| 85g net |
20pcs/box |
| 6 box/ctn |
540 cartons/20ft container |
Audited Supplier 
){kind=link}